AM Products    Home         Cart          Linear Remotes transmitters receivers
 

 DELTA3
RADIO CONTROLS
   
   Transmitters, Receivers    
Kits, Sets

DT-1   $14.99

One-button, one-channel, 9-volt battery powered visor transmitter with
removable visor clip, 256 selectable codes.

  • Activates one Delta-3 receiver
  • Test/operate LED
  • Visor mounting clip supplied
  • Power: 9-volt battery
  • Codes: 256 (set by dip switches)
  • RF frequency: 310 MHz
  • Dimensions: 2.16" W x 3.75" H x .95" D

Order number: DNT00002A     Installation Manual
DT-2    $19.99

Two-button, two-channel, 9-volt battery powered visor transmitter with
removable visor clip, 128 selectable codes.

  • Activates two Delta-3 receivers independently
  • Test/operate LED
  • Visor mounting clip supplied
  • Power: 9-volt battery
  • Codes: 256 (set by dip switches)
  • RF frequency: 310 MHz
  • Dimensions: 2.16" W x 3.75" H x .95" D

Order number: DNT00017A   Installation Manual
 DR-1   $29.99

24-volt, single-channel, three-terminal Delta-3 receiver, 256 selectable codes.

  • Activates one device
  • Wire lead antenna
  • Mounting bracket supplied
  • Power: 24 VAC/VDC
  • Codes: 256 (set by dip switches)
  • RF frequency: 310 MHz
  • Dimensions: 5.5" W x 4" H x 1.25" D

Order number: DNR00001   Installation Manual
 DS-1 Kit  $49.99

24-volt, single-channel, three-terminal Delta-3 receiver, 256 selectable codes,
with one single-button DT transmitter.

  • Radio receiver and transmitter set
  • One DR receiver
  • One DT transmitter
  • Compatible with 310 MHz Delta-3 systems

Order number: DNP00011   Installation Manual
 
 DS-2 Kit   $69.99

24-volt, single-channel, three-terminal Delta-3 receiver, 256 selectable codes,
 with two single-button DT transmitters.

  • Radio receiver and transmitter set
  • One DR receiver
  • Two DT transmitters
  • Compatible with 310 MHz Delta-3 systems

Order number: DNP00006   Installation Manual
 
 GRD -1    $49.99
GRD-2    $59.99

The GRD- is a 1 or 2-channel Gate Receiver designed for use with automatic gate
operators or systems where a remote antenna is needed. The GRD-2 can operate
two gates, one gate and an obstacle sensor, or channel one can open the gate
and channel two can close the gate. The receiver uses the Delta-3 radio format,
with 256 possible codes for each channel, set by dip-switch.

  • Auto voltage sensing - no jumpers to set
  • Two Form ”A” (normally open) relays rated at 30 Volts AC/DC up to 5 Amps
  • Supplied with whip antenna, three feet of coaxial cable, and connector
  • Power: 12 - 30 VAC or 10.5 - 30 VDC
  • RF frequency: 310 MHz
  • Dimensions: 3.625" W x 5.25" H x 1.5" D

Order number: DNR00102  Installation Manual
 TF524    $9.99

120 VAC to 24-volt VAC @ 50 mA transformer for powering
door and gate operator receivers.

  • Powers 3-terminal receiver when used with 2-terminal operator

  • 120 VAC to 24 VAC

  • 50mA maximum current

  • UL Listed

  • 3 foot cable

Order number: AAE00010


Digital Timer w Display
15A Plug-in timer
Daylight Saving
(2) Channel Clock Timer
 365 days, or Weekly, Days
 1 or 2 Relay outputs 10A
12, 24VAC/DC outdoor
Electronic Timer
7 Days- 24 Hrs- NEMA1 indoor
 SPST - 30 Amps - 120 Volt

 Warning: Radio control equipment is not to be used in life safety